Road Guard Rails C Post
Classification: Guardrail Beam C Post
Brand Name: FORST
Brief Introduction:
Guardrail BeamC Post Specifications:Normal Sizes 1830*150*60*25
Thickness:4-6mm Different sizes can becustomized Raw Material Q235B/Q355B
It has pinnacle flexibility, medical and affordable internal form, immoderate balance. commonly may be used to virtually acquire large oscillations, resistance to herbal disasters within reason sturdy.
The production process of the C post
Material selection: Cut the raw material slats, use the bending machine to form, a total of 4 times bending molding
Galvanized C-post refers to the use of steel plate new section steel, cold-rolled bending molding, uniform wall thickness, cross-section. Compared with old-fashioned hot rolling, it can save 30% of the material and the strength is the same.
Product picture of Guardrail Beam C Post：
c post
c post installation process
Can use special guardrail pile driver, pile driver pile cap to use the size of C post, general c post pile cap size can be universal, the use of air compressor power transmission, vertical pressure on the post, into the soil, cement or asphalt ground, according to different standards, retain the height above the ground 750mm, 1200mm, 450mm and so on.
The galvanizing method of C post can generally be carried out by the following steps:
1. Pretreatment: Put the pickling C-column into hot water for cleaning, remove the residual pickling agent, and neutralize the pH of the column surface with lye.
2. Electroplating treatment: Put the cleaned C post into the galvanizing tank. Under the action of current, the zinc is dissolved in the electrolyte and then deposited on the surface of the column. Galvanizing tanks usually contain acidic or alkaline electrolytes containing zinc ions.
3. End treatment: Remove the galvanized C post from the galvanized tank and let the droplets on its surface dry smoothly during the temporary hanging or drying process.
It should be noted that when performing the C post galvanizing process, it is necessary to use relevant protective equipment, such as wearing protective gloves, wearing goggles, etc. In addition, the operator should strictly abide by the safety operation procedures to ensure that personal safety and quality requirements are met.
